Accu-Strut LT Barrel strut for Ruger Minis

Click To Enlarge

Accu-Strut LT in Black is back in stock.

Accu-Strut LT Barrel strut for Ruger Minis

Barrel strut for Mini-14 and Mini-30 rifles. Provides mechanical rigidity for thin carbine barrel, reducing accuracy-killing vibrations. The 6-inch 2-clamp configuration gives your best opportunity for performance increases. Typical improvement is 50-75% reduction in group size for earlier straight-barrel rifles, and up to 33% on the new tapered barrels. Your actual experience will vary.

Undamped, lightweight version of the original Accu-strut.
Also significantly aids in barrel over-heating problems, reduces load sensitivity, and enhances the appearance of your Mini.
Proprietary Flex-clamp design accomodates newer tapered barrels, an Accu-strut exclusive.
Available in black oxide (“blued”), stainless steel, or combination finish.

Dimensions:

Length: 5-7/8"
Weight: 8.0 oz

APPLICATION GUIDE

Regular (6") Models (A2, LT, HS)

Older straight-profile 9/16" barrel

New tapered 5/8" barrel

For Ruger Mini-14 and Mini-30 with full-length barrels.
Not recommended for tapered 16” short barrel versions with flash hider as clamps will be positioned too closely together. OK for models without the flash hider.
Will not fit early 180-series, as rear of strut will interfere with sling installation point.
Will not fit rifles with mid-barrel bayonet lugs (i.e. older GB models).
Will not fit on "Target" models due to the much larger barrels.

Compatibility

Harris bipod adaptor: strut sits forward a bit to accommodate "forks". May not be able to use the rear set-screws.

ASI Tuneable Gas Block: The Accu-strut will not work with this product due to interference with the adjustment screw.

Ultimak rail: Rear clamp must be shifted forward a bit to clear extended rail.

Amega Ranges rail: installs with no modification.